Alderon 2012755 Go2 Totalizer Two Power Sources 120/230VAC
Brand:
Alderon
Part #:
2012755
Condition: 
Brand New
Brand New $778.00 /Each
$1,252.07 You save $474.07 38%
Manufacturer warranty Description
Features:
- Type 4X Enclosure, Indoor or Outdoor Use, Pad-Lockable
- Standard Enclosure Size 12" x 10" x 6" (inches)
- Opaque Door, Alarm Beacon with Red Flashing LEDs
- Alarm Buzzer and Alarm Test/Silence Switch
- Pump Circuit Breakers and IEC Contactor Pump Starters
- Pump Circuit Breakers for Pump Disconnect
- Beacon with Vibrant Multi-Color LEDs
- Green (normal/pump run), Red (alarms), and Amber (error/HOA off)
- Event LEDs will flash and normal state LEDs will be solid
- System Status LEDs (circuit board)
- Power, Pump 1/2 Run, Sensor/Float Activated, and Seal Fail (optional)
- Automatic Resettable Alarm and Control Fuses
- Built-in Printed Circuit Board Surge Protection
- Conformal Coated for Reliable Thermal and Moisture Protection
- Built-in Lag Delay Timer to Prevent Simultaneous Pump Run
- Pump Selector Switch
- Set the Lead Pump to Pump 1, Alternate, or Pump 2
- Easily Change Configurations
- Sensor Error Input, Automatic or Manual Alarm Reset, Redundant Start Enable, Low Alarm Enable, and Lag/Alarm Disable
- System Normal Beacon Disable
- Optional Seal Fail Pump Stop Enable and Seal Fail Buzzer Enable
- Sensor Options (signaling device)
- Field Wire up to (5) Digital Inputs
- Low Alarm/Redundant Off, Off, Lead, Lag, and High Alarm
- Automatic Low Alarm Enable and 6th/7th Inputs for Seal Fail (optional)
- Included Auxiliary "Dry" Contacts
- Normally Open or Closed, General Alarm (any) plus Power Loss
- Hand-Off-Auto (HOA) Pump Selector Switch (each pump)
- Off Reminder, Yellow Flashing LEDs (beacon) if both are Set to Off
- Check It Circuit Board
- Check It Button to Simulate Pump Start Events
- Configure/Test Button to Activate Alarm Test, Clear Alarms, and Enable or Disable System Configuration Settings
- Exterior Test/Silence Switch
- Activated and Deactivated less than 5-seconds, Activates Alarm Test
- Activated more than 5-seconds, Clears all Alarms
- Silence Buzzer during Alarm
Options:
- 48" Pedestal - Measured from Pedestal Bottom to Bottom of Panel
Technical details
Main features
- Cable Length 20' Cable Length
- Voltage 120/230VAC
- Mounting Method RubberLox
- Base Model Single Phase Duplex, Pump Circuit Breakers
- Number of Control Switches (Floats) (3) Control Switches - Off, Start, and High Level Alarm, Normally Open (Pump Down)
- Enclosure Size 10" x 8" x 4"
- Pump Full Load Amps (FLA) 7 - 15 Amps
Reviews.
There are currently no reviews for this product. You can leave the first review and share your experience.