Alderon 2012530 Power Post Standard Demand Dose

Use the Power Post to make a professional and safe connection for power and float switch wiring connections to your on-site septic system. The Power Post comes with a 42.5-inch post to install in the ground with the vented post cap, cable grips, and junction box all pre-installed to the post which eliminates a 4" x 4" wood post and the exposed wires. This system can be used for a wide variety of applications, including but not limited to: septic tanks, holding tanks, pump chambers, and water tanks. The Power Post allows for a safe, clean, and quick installation of pump power, pump float switch, high level alarm float switch, and is equipped with audible and visual alarm indication. There are several float switch and accessory options.

When powered, the green LED will illuminate inside the top cover of the enclosure to indicate the unit is powered on. During an alarm condition, the red LEDs will illuminate, flashing and the buzzer will annunciate. The alarm condition will stay on until the alarm float switch is deactivated. If the test/ silence pushbutton is pressed during an alarm condition, it will silence the buzzer and the red LEDs will stop flashing and remain solid. The silence condition will reset when the alarm float switch deactivates. If the alarm is in silence mode for longer than 24 hours, the alarm will reactivate. The system can be equipped with an optional Power Post indoor alarm panel (standard or WiFi) to connect a high level alarm float switch, and/or filter switch for remote notification of high level and filter service alarm conditions. A customer supplied sensor wire is used to make connections between the terminals on the remote alarm panel and the Power Post enclosure.