Alderon 2012245 Single Phase Control Panel, 120VAC, 1 - 14 Amps

Alderon, 2012245, Oil Alert OA1S120C14-L+25VOS Single Phase Simplex Control Panel, 120VAC, 1 - 14 Amps, Local Alarm with Control Panel: Alarm Test/Silence Switch and Alarm Buzzer, 25' Cable, Adjustable Pumping Range, 1" - 44" (Preset Level Sensor, Adjustable Probe)

Features:

• Type 4X Enclosure (indoor/outdoor rated)
• Clear Cover to view Interior Components
• Mounting Brackets
• Oil Alert™ Circuit Board, Status Indicators
• Incoming System Power (control/alarm, pre-wired male plug)
• Test/Configure Pushbutton
• Pump Hand-Off-Auto Selector Switch
• Remote Alarm Panel Auxiliary Contacts
• Pump Run Auxiliary Contacts
• Preset Level Sensor/Function Input Terminals (sensor only, pre-wired at factory)
• Sensitivity Adjustment Dial (water sensors)
• IEC Motor Contactor
• Pump Power Receptacle (pre-wired female plug)
• Pump Connection Terminals (pre-wired to female receptacle plug; not shown)
• Ground Bar (5-position)
• Pre-Installed Cable Grips (4)

The Oil Alert™ single-phase simplex control panel is used for the safe operation of pumping, alarming, and monitoring of: elevator sump pits, transformer vaults, and leachate well applications. The control panel will activate a pump to remove water from pits in accordance with ASME A17.1, stopping the pump before oil or other harmful substances enter the water supply. The control panel includes a pre-installed female pump power receptacle, an incoming system power cable, and a preset level sensor. The incoming and pump power must match the system voltage. Refer to the included electrical schematic for complete wiring and voltage information.

The control panel is operated by the factory-wired preset level sensor module for pump stop, pump start, high-water alarm, and oil-detection alarm (high-level float switch). As the water level rises, touching the pump start probe (middle), the pump will start and continue to run until the water level recedes below the pump stop probe (longest) to complete the pump cycle. The control panel pump run LED will illuminate when the pump is running, and the pump run auxiliary contacts will activate. Other LED status indicators are included for: power, high water alarm, high oil alarm, trouble alarm, pump stop sensor, pump start sensor, high water alarm sensor, and high level float switch.

The pump stop probe senses air or oil, and when the water level is no longer touches this probe, the pump stops running so the oil layer will not be pumped out of the sump. Oil will float on top of water, so if oil is present and touching this probe, the pump will also stop running. If the water level rises, touching the high water probe (shortest), a high water alarm condition occurs and the pump continues to run (will also act as a redundant pump start/pump run function). The alarm condition automatically resets when water is no longer touching the high water probe.

If oil, hydrocarbon, or other harmful substances are floating on top of the water level, touching the high water probe while simultaneously activating the high level float switch, then a high oil alarm (oil detected) condition occurs and the pump continues to run as long as water and not oil is touching the pump start and pump stop probes. During an alarm condition, the control panel LED(s) will illuminate while the auxiliary contacts send a signal to activate the Oil Alert™ remote alarm panel and the alarm buzzer annunciates, alarm LED indicator(s) illuminate, and auxiliary contacts activate. The auxiliary contacts of the alarm panel can be connected to a building automation system (BAS) or SCADA system and phone dialers for remote notification of alarm conditions.

For more information, please see Data Sheet