Alderon 2012136 Single Phase Duplex Control Panel, 15 - 20 Amps

Alderon, 2012136, Check It CKIT1D230C20-E5CI4S2+4AGHPS20 Single Phase Duplex Control Panel, 120/230VAC, Pump Circuit Breakers, 15 - 20 Amps, Enclosure Size 18" x 16" x 10", Control Circuit Breaker, Intrinsically Safe Circuits For 4 Floats, Seal & Thermal Pump Sensors, (4) Altra Gold Control Switches, Normally Open, Stainless Steel Pipe Clamps, 20' Cable

Features:

• Type 4X Enclosure, Indoor or Outdoor Use, Pad-Lockable
  • Opaque Door, Alarm Beacon with Red Flashing LEDs
  • Alarm Buzzer and Alarm Test/Silence Switch
• Pump Circuit Breakers and IEC Contactor Pump Starters
  • Pump Circuit Breakers for Pump Disconnect
• Beacon with Vibrant Multi-Color LEDs
  • Green (normal/pump run), Red (alarms), and Amber (error/HOA off)
  • Event LEDs will flash and normal state LEDs will be solid
• System Status LEDs (circuit board)
• Automatic Resettable Alarm and Control Fuses
• Built-in Printed Circuit Board Surge Protection
  • Conformal Coated for Reliable Thermal and Moisture Protection
• Built-in Lag Delay Timer to Prevent Simultaneous Pump Run
• Pump Selector Switch
  • Set the Lead Pump to Pump 1, Alternate, or Pump 2
• Easily Change Configurations
  • Sensor Error Input, Automatic or Manual Alarm Reset, Redundant Start Enable, Low Alarm Enable, and Lag/Alarm Disable
  • System Normal Beacon Disable
• Included Auxiliary "Dry" Contacts
  • Normally Open or Closed, General Alarm (any) plus Power Loss
• Hand-Off-Auto (HOA) Pump Selector Switch (each pump)
  • Off Reminder, Yellow Flashing LEDs (beacon) if both are Set to Off
• Check It™ Circuit Board
  • Check It™ Button to Simulate Pump Start Events
  • Configure/Test Button to Activate Alarm Test, Clear Alarms, and Enable or Disable System Configuration Settings
• Exterior Test/Silence Switch
  • Activated and deactivated in less than 5-seconds, Activates Alarm Test
  • Activated for more than 5-seconds, clears all Alarms
  • Silence Buzzer during Alarm

For more information, please see Data Sheet