Drive Unit/Pump Size | C060: 15.8 GPH (60 LPH) |
Wet End Material | 316SS/PTFE |
Connections | MNPT |
Controller Location | Right Face |
Power Cord | USA (230V) |
Pulse control | 0.00625mL/PLS - 120mL/PLS |
Batch control | 6.25mL/PLS - 120L/PLS |
MAN (Manual) | Use the UP and DOWN keys to adjust a flow rate |
ANALOG fixed control | 4-20mA, 0-20mA, 20-4mA, 20-0mA (Proportional to the flow rate) |
ANALOG variable control | 2-setpoint programmable (0-20mA, proportional to flow rate) |
Interval batch control | Day: 0 - 9, Hour: 0 - 23, Minute: 1 - 59 |
Profibus control | Communication protocol: Profibus-DP-compliant International standard: EN50170 (IEC61158) |
Monitor | LCD 16 digits x 2 lines, backlit character LCD / LED WHITE: Pump stopped/waiting. ORANGE: Running, Pre-Stop condition. GREEN: Pump operating. RED: Alarm condition/stopped. |
Keypad | Start/Stop, MENU, ESC, Enter, Up, Down, Left and Right keys |
STOP | Operation stops/starts with input contact |
PRIME | Forces max. speed operation by pressing the UP and DOWN keys |
Keylock | Locks/unlocks keypad operation with PIN code |
Interlock | Operation stops/starts with input contact |
AUX | Pump operates at programmed flow rate with input contact |
Maximum discharge rate | Adjusts maximum flow rate limit of pump |
Buffer memory | Enables memory or ignoring of incoming pulses during operation in Batch mode |
Analog input display | Displays the actual analog input value |
STOP/Pre-Stop/AUX/Interlock | No-voltage contact or open collector |
Input Analog | 0-20mA DC (Internal resistance is 200Ω) |
Input Pulse | No-voltage contact or open collector. Max pulse frequency: 100Hz |
Output Alarm1 (OUT1) | - No-voltage contact (mechanical relay): 250VAC 2A (Resistive load)
- Possible output conditions can be Enabled/Disabled: STOP / Pre-Stop /
- Interlock / Leak Detection / Motor Overload/ Batch CompleteNote4/ Drive Error
- Factory preset: Leak Detection is Enabled for OUT1
|
Output Alarm2 (OUT2) | - No-voltage contact (PhotoMOS relay): AC/DC 24V 0.1A (Resistive load)
- Possible output conditions can be Enabled/Disabled: STOP / Pre-Stop / Interlock
- Leak Detection / Motor Overload/ Batch Complete / Drive Error /
- Volume Prob. PLS
- Factory preset: Interlock is Enabled for OUT2
|
Power supply | 12VDC 30mA maximum |
Current | DC 0-20mA, 2 programmable setpoints (Max. resistance load: 300Ω) |
Power voltage | 100-240VAC 10% 50/60Hz |