Televes 536080 Low-Gain Mast Amplifier with 2 Inputs

Televes, 536080, Low-Gain Mast Amplifier with 2 Inputs and "F" Power Supply

536080 Includes Only:

• (536020) Low-gain mast amplifier
• (550104) "F" Power Supply Unit

Features:

• Independent amplification for each band
• EasyF connection system
• Fully automated manufacturing, subject to the most stringent quality controls
• High-screening Zamak chassis
• ON/OFF switches to allow DC to pass towards the UHF inputs for the powering of a BOSS system
• Easy mounting. Equipped with a plastic tie for mast mounting
• Resistant ABS-plastic orange case for outdoor installation

Masthead amplifier for the amplification of terrestrial television signals coming from several antennas. Equipped with 2 inputs, with amplification on all bands. The amplifier is powered through the output coaxial cable at 12 VDC.

12 V-power supply (220 mA) that powers equipment through the input coaxial cable while allowing the transmission of the TV signal. Included in the installation to power either mast amplifiers or a BOSS system. Furthermore, it is equipped with two outputs. The power supply is UL-certified (US plug).

EasyF Connection System: Simplicity and Savings

EasyF is an innovative connection concept where the inner conductor of the coaxial cable is directly inserted into the device, thus improving connection reliability. Thanks to the absence of F connectors, the chassis can be reduced, and the connection of two cables is secured with a single screw.

• Real-time savings: speeding the installation is possible without the need for coaxial cable termination. Furthermore, there is no need for screwing the connectors on the device, which is sometimes difficult when there is little room
• Connection reliability: the clamp holding the cables prevents the coaxial cable from coming off
• Cost savings: no additional connectors are required (neither F nor IEC)
• Space optimization: inputs and outputs are always on the same side of the device to prevent coaxial cables from bending, and to make working inside cabinets and register boxes easier
• Very easy three-step mounting: only screwing and unscrewing the covers is required to connect both cables:
  • Unscrew the device's cover to access the connection
  • Insert the previously stripped coaxial cables
  • Close the cover and screw to ensure the connection

Learn More About EasyF System Reliability

With EasyF, the connection between the coaxial cable and the device is carried out using an automated system for contact insertion of the inner conductor, without any soldering.

• The device's operating life increases when the factor of solder wearing out with time is removed
• Failure rate reduction: usually produced as a result of cold soldering joints
• Electromagnetic behavior optimization: for high frequencies
• Commitment to the environment is reinforced: pollution caused by the welding process is eliminated and production power consumption is reduced