Sifam Tinsley Gamma 50 General Series Dual Display Digital Multimeter

Sifam Tinsley, Gamma 50, General Purpose/Industrial Grade Series Dual Display Digital Multimeter, 6600 Counts, Current Measurement upto 16A CAT III 1000 V / CAT IV 600V with Backlit

Gamma 50 Includes Only:

• 1 x Cable set
• 1 x Multimeter
• 1 x Copy Operating Instructions
• 1 x Protective Case (Holster).

Features:

• Root mean square value with distorted waveform (for 616 only). The measuring principle employed permits the measurement of root mean square value (TRMS) of AC quantities regardless of the waveform.
• Auto Power OFF (APO).
  • The multimeter has a default auto power-off function. If the Meter is idle for more than 15 minutes, the meter automatically turns the power off. Dual Display The dual display included a main display and a sub-display. The main display always displays the current measurement value whereas the display shows some special measurements like maximum/minimum value and reference value for relative value measurement. Also, a dual display is used to display the same time Voltage/ Current with Frequency, Frequency with Duty cycle, etc.
• Indication of negative values on the analog scale. When measuring DC quantities negative values are shown on the analog scale so that variations of the estimated value can be observed at the Zero point.
• Protection from dust and water.
  • Instrument: IP 52
  • For terminals: IP20 as per IEC60529.
• Applicable International Safety Standards. 1000 V CAT III/600V CAT IV as per International Safety standard IEC 61010-1- 2010 and IEC 61557
• Hold. By pressing the HOLD/ON key, the currently displayed Measurement value can be held, and "HOLD" is simultaneously displayed.
• Relative measurement (REL). By pressing and holding PEAK and then pressing the AUTO/MAN key, the zero correction is made and the relative Value is measured. It is not active in Hz/Duty functions.
• Automatic blocking System(ABS). The automatic terminal blocking system prevents incorrect connection of test leads and incorrect selection of measurement quantity, which provides safety to the user.
• Backlit. Large white LED backlit to work in poorly light areas.
• Continuous ON mode. In this mode, AUTO POWER OFF is disabled.
• Auto and Manual ranging modes.
  • In AUTO ranging mode the instrument automatically selects the range with best resolution depending on the applied input.
  • In manual ranging mode, the range is user-selectable using the AUTO/MAN Key. Note: For AAC, ADC, Temperature, Continuity, Diode, and Duty cycle measuring range is manual. No AUTO range selection is possible.
• Diode and Continuity testing. This provides for the testing of the polarity of diodes, as well as inspection for short circuits and circuit interruptions. In addition to the display, the resistance of less than 30Ω (approx. )

Digital multimeters are suited for universal, general applications in the electrical and electronics radio and television service, training, and education.

For more information, please see Data Sheet