Meg-Alert, GP5000-CG-HV-AS, CableGuard Automatic Single Generator Insulation Tester Kit with Analog Switchboard Meter, 5000 VDC
GP5000-CG-HV-AS Includes Only:
- 25 KV internal isolation relay
- GP7000-5 1% analog switchboard meter
- GP8012-MU-AS remote LED / Switch assembly with power on/test on/pre-alarm/alarm LED indicators and 15 ft. cable
- GP10016 HV fuse block assembly
- GP10050 HV test lead assembly.
Features:
- Auto/Manual test operation
- Adjustable alarm and pre-alarm set points
- Latching alarm contacts with manual reset
- Pre-alarm contacts with auto reset
- Full 5000 VDC test voltage
- Fused input and HV test lead
- 15 ft. two-way current-limited H.V. test lead w/plug
- Non-corrosive, lightweight enclosure
- Remote Calibration and system test switch
- Long-life, flashing remote LED/switch assembly w/15 ft. cable
- 1% Panel meter with 4" color-coded dial
- 15 kV test lead with current limit resistor-15' length
Applications:
- Shore Power Cables
- Shore Power Plugs and Receptacles
- Power Feed Cables and Busses
- Distribution/Isolation Transformers
Automatic Insulation Resistance Tester that monitors and protects critical-duty cable and transformer circuits.
Operation
CableGuard applies a current-limited, fixed DC voltage to the cable circuit during idle periods. A solid-state comparator circuit monitors measured leakage current to the ground. Two adjustable set points, factory preset to customer specifications, can be programmed to signal a pre-alarm, alarm, and lockout the equipment from operating if the low set point is exceeded. The manual reset feature enables a return to operational status only after the alarm condition has been corrected. CableGuard will not impair the normal operation of the equipment being monitored.
For more information, please see 
Wiring Diagram
