Features:
- NEMA 4/4x stainless steel enclosure
- One-inch-high bright, bold, 6-digit LED display
- 8 selectable modes of operation: Normal Gross, Tare & Net, Print
- weight and total, Auto print weight and total, Unattended axle
- weighing short and long scales with traffic light control, peak hold,
- over/under Check weigh, and bulk weigh
- Programmable in Scale Basic macro language for application
- development (event driven)
- Simulates A&D, Condec, Weigh-Tronix, Ohaus communication
- protocols; user configurable protocol
- Selectable 5-point calibration for improved accuracy
- 24-bit A/D with 60 or 100 samples/second conversion rate
- Signal sensitivity to 0.1 uV/graduation
- Selectable digital filter to eliminate weight vibrations
- Powers up to 12 x 350 or 24 x 700 load cells
- Two serial ports: RS232, 20mA current loop and RS485
- Digital port for relay control and remote operation
- Primary and secondary units with conversion factor
- 32K RAM provides 500 ID storage for part, truck, etc.
- Selectable address for multi-drop RS485 network interface
Applications:
- Gross, tare and net weighing
- Vehicle and railroad weighing
- Multi-container or axle weighing
- Weigh system interface to Distributed Control System
- Batching and process control systems
- Drum filling, tank, hopper, bench and floor scales
- Over/Under check-weighing and material-testing
- Chemical and Wash down environments
- Hazardous environments with optional IS barriers
The IDS 410 is the only digital weight meter in its class that is fully programmable in an easy and flexible macro language called Scale Basic. In addition to the built-in modes of operation, Scale Basic allows you to customize the operation of the IDS 410 to meet your application requirements. The Scale Basic language provides various commands and functions that include: math operations, I/O control, set points, timers, data entry, ID storage, message display, and program sequence control among others. Programming the IDS 410 can be performed through the keyboard or a PC using the optional EZ-LINK software that greatly facilitates setup and programming. mode 0 - Normal Basic gross, tare and net weighing mode 1 - Print Weight and Total (Numbered Weights)Prints numbered weights with a total of accumulated gross,tare or net weights mode 2 - Auto Print and Total Weighing/Multi-Container/Pallet Auto prints multiple numbered gross or net weights and keep a running total for a job, lot, pallet, truck etc. Prints accumulated gros stare and net totals when finished. mode 3 - Unattended Axle Weigh and Print (Short Scale)Unattended short scale vehicle axle weighing application provides traffic light control, remote display interface and auto finish totaling mode 4 - Auto Axle Weigh (Long Scales)Same as mode 3 but previous axles are auto zeroed for long scale. mode 5 - Peak Hold mode (Force Measurement)Display or print the gross or net of detected peak force/weight mode 6 - Over/Under Check weigh Provides 3 TTL outputs and 2 set points to indicate over, under and between weight conditions. Outputs can activate lights or alarms mode 7 - bulk weighProvides set point entry and relay output to control fill process.Remote start/stop operation with configurable scale empty and draftweights. Use for multiple drafts with subtotal and total printing