Eastwood 54290ZP Rust Encapsulator Plus Matte Black Paint Quart

Features:

• 2X stronger than original Rust Encapsulator
• Passed over 1,000 hours of salt spray testing
• Best used in non-direct sunlight applications
• Should be top coated in direct sunlight applications
• Direct to metal or apply over rust
• Heat resistant up to 350°F
• Only one coat required for full coverage - saves you money
• Easy application: roll, brush, or spray
• Better than hardware store aerosols
• Outperforms all competitors and heat stable to 350°F
• Only 2 quarts required for full-size car or truck frame
• Looks great or topcoat with your product of choice

Application:

• Prepare substrate by wire brush cleaning loose corrosion.
• Solvent wipe with PRE or Acetone to remove oil, grease, or other contaminants. Allow to dry thoroughly before coating.
• Apply product when surface temperature is between 40°F and 80°F with humidity from 10% to 75%. Note: Assure moisture is not accumulating on the surface to be coated.
• Apply one medium wet coat with a bristle brush or roller, ensuring all cavities and areas of corrosion are covered. Note: Product can also be thinned up to 20% with Xylene and spray-applied with traditional HVLP gravity or siphon spray equipment using a 1.4mm minimum needle/nozzle.
• Product will be tack-free after 2 hours.
• If top coating: apply top coat after 4 hours or before 48 hours. Note: If a smoother surface finish is desired, product can be mechanically sanded with 320 grit before top coating.
• If top coating is desired after 48 hours, surface must be scuff-sanded with 320 grit paper to ensure top coat adhesion.
• Clean all spray equipment with acetone or lacquer thinner.

Eastwood has been one of the leading names in rust prevention for many years. Now we bring you twice the corrosion resistance of original Rust Encapsulator in a simple to apply moisture cure coating. Spray it, brush it or roll it on. It does not matter, just get it on to protect your next project from corrosion.

After usage, wipe recess of can with clean rag and solvent to remove any product. If product is left in lid area recess of can and lid is re attached, the product will bond the two pieces together. This will render the product useless, as it will be very difficult to separate the lid from the can. It is highly recommended to use this product in conjunction with a plastic mixing cup and lid for short term storage after initial use.