20566 Includes Only:
- (1) Eastwood TIG 200 DC Welder with NEMA6-50P Plug
- (1) Shielding Gas Regulator
- (1) Shielding Gas Hose
- (1) Ground Cable with Clamp (10')
- (1) WP #17 TIG Torch (14')
- (1) Foot Pedal for Amperage Control
- (1) 110-120 VAC to 220-240 VAC Adaptor Plug
- (1) Instruction Manual
- (1) Hand Held Shield
- (1) Hammer/Brush
- (1) #7 Gas Nozzle (7/16")
- (1) #6 Gas Nozzle (3/8")
- (1) #5 Gas Nozzle (5/16") (Installed)
- (1) Long Back Cap
- (1) Short Back Cap (Installed)
- (1) 3/32" Collet Body (Installed)
- (1) 3/32" Collet (Installed)
- (1) 1/16" Collet
- (1) 2.0mm Collet
- (1) 1/16" Red Thoriated Tungsten
Features:
- DIY-friendly welder handles both mild and stainless steel up to 1/4-in thick
- DC power inverter delivers between 10 and 200 amps for a range of project needs
- Includes hand-held torch with on/off switch for reliable starts
- Remote foot pedal infinitely controls amperage for precision
- High-frequency start ensures instant arc strike with no tungsten contamination
- Power-sensing internal circuitry automatically adjusts to power outlets from 110-240V
- Factory-programmed shielding gas pre-fow and post-flow for convenience
- Can also stick weld in DC +/- mode
- Lightweight design weighs just 18 lbs
Get started with TIG welding is easy with the Eastwood TIG 200 DC welder. Designed for DIY enthusiasts, this compact 200-Amp TIG welder is capable of welding both mild and stainless steel up to 1/4-in. thick without the cost of an AC inverter. Its DC inverter power supply provides output ranging from 10- to 200-Amps, ideal for a wide variety of repair and fabrication projects.
The TIG 200 DC is easy to set up and use. Equipped with power-sensing circuitry, it automatically adjusts to power inputs from 110V to 240V, letting you plug it in almost anywhere. The handheld torch includes an on/off switch to start the arc and a remote foot pedal controls amperages for precise welding control. A high-frequency start guarantees an instant arc strike with no tungsten contamination. Pre-flow and post-flow gas settings are pre-programmed at 0.5 sec (pre) and 5 sec (post) for convenience.
Compact and lightweight (just 18-lbs), the TIG 200 DC is exceptionally portable. It can also work as a stick welder in DC positive/negative mode. Does NOT weld aluminum.
Duty Cycle
The rated Duty cycle refers to the amount of welding that can be done within an amount of time. The Eastwood TIG 200 DC has a duty cycle of 60% at 190 Amps. It is easiest to look at your welding time in blocks of 10 Minutes and the Duty Cycle being a percentage of that 10 Minutes. If welding at 190 Amps with a 60% Duty Cycle, within a 10 Minute block of time you can weld for 6 Minutes with 4 Minutes of cooling for the welder. To increase the duty cycle you can turn down the Amperage Output control. Going above 190 Amps will yield a lower duty cycle.
For more information, please see 
Data Sheet
