Features:
- Gray in color
- Corrosion resistance for greater durability (tested to 500 hours in a salt-spray chamber)
- Epoxy-fortified for better adhesion and topcoat compatibility
- Penetrates deeper to prevent rust from spreading or forming, even in hard-to-reach areas
- Cures faster, and the low-VOC formula is acceptable in California
- Coverage: about 10 sq. ft. per can
- Gloss Level: 2.3%
- Excellent Chemical Resistance to Gasoline, Anti-Freeze and Motor Oil. Also resists DOT 3 brake Fluid and Acetone
- Superior UV Resistance
- Cured Thickness: 1 Mil
- As seen on "My Classic Car" TV show
Stop rust in its tracks! Rust Encapsulator (Gray) has been formulated with SUPERIOR corrosion resistance to "hardware store rust paints"! You thought it was good before...wait 'til you try this Rust Encapsulator! It seals and stops rust and corrosion from spreading, but it performs even better than original formula. Tested against well-known brands, the Eastwood Rust Encapsulator has proven to be superior in sunlight resistance, preventing rust creep, and overall durability.
Use a wire brush to remove loose rust, scale and paint, and remove dust, grease and oil deposits. Feather surrounding paint with 220-grit sandpaper. Shake can for at least 2 minutes once the mixing ball starts to rattle. Hold the Rust Encapsulator can 10-12" above surface as you spray. A single coat dries to the touch in 20 minutes, and is thoroughly dry in 3-4 hours at 68°F. For greater durability, a second coat can be applied 1 hour after the first. Allow 6-8 hours after the last coat before applying topcoat. Use over or under body fillers.
Safety Information:
Always wear eye, skin and respirtaory protection. Apply in a well ventilated area away from open flame.
