165-RTDW-R25N Includes Only:
- 165-gallon Roth UL SU 2258 double-wall tank
- Inner wall molded polyethylene, outer wall galvanized steel
- Reel-mount bracket
- Tank base
- 5:1 pump
- 1/2" x 50' oil reel package
- Air coupler
- Air connector
- Air filter/regulator with gauge
- 5' air connecting hose
- 2' oil connecting hose
- Vented fill cap
- Float and string type sight gauge
- Leak detector
- Non-metered control handle with flexible extension
- Manual non-drip nozzle
The Roth Double Wall Safety Fuel Oil Storage Tank (DWT) is made with a seamless blow-molded polyethylene inner tank and a 19 ga. galvanized outer tank. The outer tank is formed by joining cold rolled sheet steel, used to form the sides and bottom from a single piece, with two stamped metal end pieces. The edges between the sides and ends have sealant applied to them and are then rolled to create leak-proof seams. A stamped top is then pressed and riveted into place to complete the assembly of the DWT. The DWT is UL listed in the United States and Canada under SU2258 and approved under NFPA 31 (2001) and CSA B-139- 04 as non-metallic fuel oil storage tanks.
Both inner and outer tanks are pressure tested at the factory during assembly according to UL standards and do not require further field testing. The DWT also comes with a detached saddle base which the tank is placed on at the time of installation.
The tank shall be placed into service in accordance with local codes and the listed use (indoor or outdoor) on a flat, level and stable surface, away from heat sources, corrosive atmospheres or fluids, potential mechanical damage or rapid temperature changes. The final location must have the tank label visible after installation. A minimum of 2" (50 mm) from all walls or obstructions is recommended for normal tank expansion and visual inspection. The integral base support shall not be removed and raising the tank height is not allowed except on a continuous concrete platform at least 6" (150 mm) wider than the tank base at all sides. All local fire code set-backs for fuel oil storage tanks must be observed.
Tanks installed indoors shall not be exposed to direct sunlight on any plastic parts. Tanks installed outdoors shall be assembled with the required cover, Roth #2335100749 for the 620L.
