Altelix, NP14GYVA1C-WEXT, Weatherproof Vented WiFi Enclosure with No-Drill Equipment Mounting Plate, 120VAC Outlets and Power Cord
NP14GYVA1C-WEXT Includes Only:
- Enclosure
- Wall Mounting Hardware
Features:
- Plug-and-Play Design, Easy to Install
- Dual 3' Vents with Rain Shields to Expel Heat
- Features a RF Transparent PVC Non-Metallic Equipment Mounting Plate
- Pre-Wired 120VAC Power Outlet with 5 foot Power Cord
- NEMA Type 3R, 3RX / IP24 Rated
- Weatherproof and UV Stable
- Durable Polycarbonate + ABS Construction
- Gasketed Lid Featuring a Tamper-Proof Locking Screw with Key and Provision for Padlock
Applications:
- WiFi Repeater Enclosure
- WiFi Extender Enclosure
- Multi Purpose Plastic Utility Box
- LED Controllers
- IoT Devices
- WiFi Gear
- Security and Surveillance Systems
- Outdoor Weather Protection
- Protection Against Theft or Damage
- Warehouses and Public Areas
- Concealment of Equipment
Extend Your Wireless Coverage to Outdoor Locations
The Altelix NP14VA1C-WEXT is a vented weatherproof enclosure designed to provide added security from vandalism and protection from harsh environments, while allowing ventilation for installed equipment. It features two 3' inch air vents with rain shields and screens.
Rugged Polycarbonate + ABS Construction
This sleek enclosure is molded out of UV resistant Polycarbonate + ABS, an industrial grade plastic with greater strength and durability than standard ABS. It features a gasketed hinged door with dual latches, a stainless steel security screw and provision for padlock. Integrated mounting feet simplify installation. It meets or exceeds NEMA 3R, 3RX and IP24.
Plug and Play Setup
The Altelix NP14VA1C-WEXT enclosure provides easy plug-n-play installation. Once the enclosure is mounted, plug the installed equipment into the pre-wired 120VAC power outlet. Then plug the enclosure's 5 foot power cord into a 120VAC power outlet and you are up and running. A cable grommet on the enclosure allow cables to be connected to the device if needed.
No-Drill Non-Metallic Equipment Plate
This configuration consists of the PC+ABS enclosure with hinged lid and a 1/4' thick non-metallic PVC plate for mounting and securing equipment. Due to the 'No-Drill' design of this PVC plate, mounting radios and other equipment can be done simply by using self-tapping screws.
RF Transparent Design
The non-metallic design of the enclosure and equipment mounting plate is RF transparent and will not interfere with the WiFi signal range or coverage pattern of any wireless devices installed inside the enclosure.
Complete with Cable Grommets and Glands and Wire Management Straps
For convenience, the included accessory kit contains cable grommets and glands, wall anchors, zip ties, hook-and-loop wire management straps, door locking key and more.
