Features:
- Requires 24Vdc for Strobe Use. Installs Onto 4" Sq. Elec. Box (With Time Delay Circuitry)
- Precision engineering
- Hi-brightness strobe
- Built-in timer circuitry
- Multiple applications
- Low-power operation
- Easy to install and operate
This Strobe is Designed to Work with the Alpha Communications Ia543 Amplifiers and Other Devices That Provide a Dry Contact Closure. This Strobe will Not Work with the Older Pk543, Pk543A, And/Or Pk205 Amplifiers. For Those Systems You Must use the #Li404B Strobe Unit.
The Alpha Communications® LI424B strobe is a high-intensity remote visual signaling device which is typically used with the Alpha Communications® IA543 amplifier apartment intercom systems, and optionally with the Alpha Communications® IA502 multi-entrance transfer relay(s).
Due to its versatility, the LI424B can also be used as a stand-alone device, which can be triggered by a dry contact pushbutton or dry contact relay closure.
The unit is primarily for use in locations where hearing-impaired persons require supplemental call notification, but can be used anywhere that a visual indication of an incoming call is desired. The bright strobe light flashes once a second for approximately 20-35 seconds when an incoming call is detected (depending on amperage of the 24VDC power supply).
The device can be installed onto a standard 4-inch square electrical box or similar indoor openings. It is not a weatherproof device and therefore should not be used for any outdoor applications. Installation is facilitated by use of simple connections to the pre-mounted circuitry and a complement of mounting hardware.
The strobe light unit(s) shall be Alpha Communications® LI424B or approved equal. Operation shall be accomplished by placing a call to an apartment intercom (or video-intercom) station. The strobe shall flash for approximately 20-35 seconds after activation of the incoming call signal.
The strobe light shall have a brightness of 15 candela per UL® 1971 (75 candela per UL® 1638). It shall be encased in an attractive, flame retardant type ABS plastic housing.
The strobe light shall meet ADA and UL® requirements for signaling appliances. The strobe shall be powered by the appropriate 24VDC power source (IA543, PK601A or equivalent). Current draw shall be 120mA. Contractor shall observe all local and national electrical and building codes.
