Alderon, 2011831, DoubleMax DM15UPS2WOP30BOX 2-Float Pump Switch, 208-240 VAC, Bare Lead - Without Plug, 30' Cable
Features:
- DoubleMax™ Housing - The float switches and power cable wires are encapsulated in epoxy to ensure a waterproof pump switch. Madewith ABS plastic and mounted on a pipe along with the start/stop floatsat the desired levels.
- Pipe Clamp Bracket - Located on the back of the DoubleMax™ housing, used to mount the pump switch to a pipe.
- Stainless Steel Pipe Clamps - Three pipe clamps are included to mount the housing, top float switch, and bottom float switch to a pipe at the desired mounting locations.
- Cable Clip - Clip the Power Cable to the housing as a way to train the power wire to go vertically.
- DoubleMax™ Power Cable - SJOOW (UL/CSA), 14 gauge, 3-conductor, flexible, and water/oil resistant.
- Pump Float Switch Cable - SJOOW (UL/CSA), 14 gauge, 2-conductor, flexible, and water/oil resistant.
- Top Float - The top float is mounted on a pipe at the desired start/run level (normally open/pump down, green collar) or stop level (normally closed/pump up, red collar) using the provided pipe clamp. The narrow-angle (20°) switching differential provides precise activation and deactivation of the float switch.
- Bottom Float - The bottom float is mounted on a pipe at the desired stop/off level (normally open/pump down, red collar) or start level (normally closed/pump up, green collar) using the provided pipe clamp. The narrow-angle (20°) switching differential provides precise activation and deactivation of the float switch.
The DoubleMax™ 2-Float Pump Switch is used to turn a pump on and off in environments with temperatures up to 140° F. This product can be used for a wide variety of applications, including but not limited to: septic tanks, sump pits, holding tanks, pump chambers, water tanks, and any other liquid tanks.
The two floats create an adjustable pumping range between 3" - 48", based on the mounting location of the floats. The pump switch is mechanically operated and activated by the ball inside the float housings. for use as empty tank (normally open) or fill tank (normally closed) configuration with stainless steel pipe clamp float attachments for mounting and various cable lengths.
NOTE: Check to make sure the correct pump switch is being used for the application:
- Normally Open - Contacts are open while hanging down and will close on a rising liquid level. Typically used for empty tank applications.
- Normally Closed - Contacts are closed while hanging down and will open on a rising liquid level. Typically used for fill tank applications.
For more information, please see 
Data Sheet
