Alderon, 2011550, Vizzyalarm VZW-023D 1-Zone WiFi Alarm, Type 1 (Indoor), 120VAC - Alarm Panel Only, (3) A5NHPR20BAG; 20' Altra Narrow Angle Control Switch, Normally Open (High Level), 120/240VAC, 5A, RubberLox Pipe Clamp, Bagged
Features:
- Power LED - A green LED illuminates (solid) on the front of thealarm panel to indicate the power is on.
- Alarm LED - During an alarm condition, the red alarm LED willilluminate (solid/slow flash) on the front of the alarm panel.
- WiFi LED - A blue LED illuminates (slow flash) when a WiFiconnection is established and (solid) when connected to Vizzy.Site™.
- Alarm Buzzer - The alarm buzzer will annunciate (solid) in additionto the visual indication provided by the red alarm LED during analarm condition.
- Test/Silence Pushbutton - Press to test the alarm; all LEDsshould illuminate (quick flash) and buzzer should annunciate (quickpulse) after approximately 5-6 seconds. During an alarm condition,press to silence the buzzer.
- WiFi Connect Pushbutton - Press to select either WPS or HTTPmode and establish a WiFi connection to an IP address.
- Sensor Inputs - Connect a field installed sensor to the terminalsfrom the monitoring area.
- Auxiliary Contacts - Interface with an external device includingBAS systems and phone dialers. The normally open dry contacts canswitch 30VDC, 700mA maximum (each).
- Battery Backup - Install (3) AA batteries (not included) for batterybackup during power outages. The green power LED will illuminate(slow flash) during battery backup mode to conserve battery power.
- Panel Access - Pull the cover off to access the panel, includesan open wiring compartment to safely route wires while connectingsensors and auxiliary dry contacts.
The Vizzyalarm™ 1-Zone WiFi Alarm is an indoor-rated alarm panel, powered by a standard 120VAC wall outlet. The green power LED will illuminate (solid) when powered. The Vizzyalarm™ is a multipurpose alarm panel that can be used for a variety of applications, including but not limited to: septic tanks, sumps, holding tanks, pump chambers, water tanks, flow, pressure, condensate, temperature, and any others where a "dry" contact can be connected to the alarm panel. Connect and register your wireless device to the Alderon™ cloud-based Vizzy.site™ to begin monitoring and receiving text and email alerts for system conditions.
The alarm panel is equipped with audible and visual alarm indication, activated by a normally open or normally closed sensor wired to the terminals and/or the low battery alarm detection. A variety of sensors can be used such as a float switch, pressure switch, or any "dry" type sensor that "closes" during an alarm condition (normally open or normally closed). Installing (3) AA batteries (not included) provides battery backup during power outages. Use the auxiliary contacts to connect to building automation systems (BAS) and phone dialers. Multiple sensors (signaling device) can be connected for expanded monitoring.
An alarm condition occurs when the sensor (signaling device) contact is activated, during which the red alarm LED will illuminate (solid), buzzer will annunciate (solid), and the auxiliary contacts will activate. The alarm condition will stay on until the sensor is deactivated. If the test/silence pushbutton is pressed during an alarm condition, it will silence the buzzer while the alarm LED remains on (solid) with activated auxiliary contacts (alarm LED slow flash). The silence condition will reset when the sensor deactivates and the alarm panel will auto-reset for the next alarm cycle.
For more information, please see 
Data Sheet
