Industrial Data Systems, IDS433D/C, Multi-Function Indicator, 12VDC Input Power
Features:
- NEMA 4X/IP66 stainless steel Wash down enclosure
- One-inch-high bright, bold, 6-digit LED display
- 19-key audible with tactile feel membrane keyboard (sealed)
- 8 selectable modes of operation: Normal; Fill to set point;
- Over/Under Check weigh; Vehicle Weigh-In/Out with Totals; MultiContainer/Axle Auto Weighing with Total; Auto Weigh & Print; Auto
- Axle Weigh with Traffic Light Control (Short/Long Scales); ID Tare,
- Print & Total; Peak Hold
- Programmable in Scale Basic macro language for application
- development (event driven)
- Simulates A&D, Condec, Weigh-Tronix, Ohaus communication
- protocols; user configurable protocol
- Selectable 5-point calibration for improved accuracy
- 24-bit A/D with 60 or 100 samples/second conversion rate
- Signal sensitivity to 0.1 uV/graduation
- Selectable digital filter to eliminate weight vibrations
- Powers up to 12 x 350 or 24 x 700 load cells
- Two serial ports: RS232, 20mA current loop and RS485
- Digital port for relay control and remote operation
- Primary and secondary units with conversion factor
- 32K RAM provides 500 ID storage (part, truck, etc.)
- Selectable address for multi-drop RS485 network interface
Applications:
- Gross, tare and net weighing
- Vehicle and railroad weighing
- Multi-container or axle weighing
- Parts counting and weighing
- Weigh system interface to Distributed Control System
- Batching and process control systems
- Drum filling, tank, hopper, bench and floor scales
- Over/Under check-weighing and material-testing
- Chemical and Wash down environments
- Hazardous environments with optional IS barriers
The IDS 433 is preprogrammed with 7 different modes of operation to accommodate most of the basic industrial scale applications.The mode is selected and easily configured from the keyboard during initial setup. The unit will operate in the mode selected until the user reconfigures it.
mode 0 - Normal Basic gross, tare and net weighing mode 1 - Fill to set point single set point fill with relay output control and weight print mode 2 - Over/Under Check weigh Provides 3 TTL outputs and 2 set points to indicate over, under and between weight conditions. Outputs can activate lights or alarms mode 3 - Vehicle Weigh-In/Out with Totals Weigh-In/Out program for up to 500 vehicles; Maintains running totals for each vehicle; Provides reporting functions mode 4 - Multi-Container/Axle Auto Weighing Auto weighs and prints each weight placed on the scale; Each weight is sequentially numbered and accumulated; The total can be printed manually or automatically; Provides traffic light control mode 5 - Auto Axle Weigh (Long Scales)Same as mode 4 but previous axles are auto tared mode 6 - ID Tare, Print and Total Provides tare entry and recall by ID; Prints ID, sequence # and GTN weights; Keeps running totals by ID; Provides reporting functions mode 7 - Peak Hold mode Display or print the peak gross or net weight detected
