Industrial Data Systems, IDS422A/O, Multi-Function Indicator, Isolated Analog Output
Features:
- Mild cold rolled steel with polyurethane texture finish enclosure
- One-inch-high bright, bold, 6-digit LED display
- 8 selectable modes of operation: Normal Gross, Tare & Net, Print
- weight and total, Auto print weight and total, Unattended axle
- weighing short and long scales with traffic light control, peak hold,
- over/under Check weigh, and bulk weigh
- Programmable in Scale Basic macro language for application
- development (event driven)
- Simulates A&D, Condec, Weigh-Tronix, Ohaus communication
- protocols; user configurable protocol
- Selectable 5-point calibration for improved accuracy
- 24-bit A/D with 60 or 100 samples/second conversion rate
- Signal sensitivity to 0.1 uV/graduation
- Selectable digital filter to eliminate weight vibrations
- Powers up to 12 x 350 or 24 x 700 load cells
- Two serial ports: RS232, 20mA current loop and RS485
- Digital port for relay control and remote operation
- Primary and secondary units with conversion factor
- 32K RAM provides 500 ID storage for part, truck, etc.
- Selectable address for multi-drop RS485 network interface
Applications:
- Gross, tare and net weighing
- Vehicle and railroad weighing
- Multi-container or axle weighing
- Weigh system interface to Distributed Control System
- Batching and process control systems
- Drum filling, tank, hopper, bench and floor scales
- Over/Under check-weighing and material-testing
- Hazardous environments with optional IS barriers
The IDS 422 is preprogrammed with 10 different modes of operation to accommodate most of the basic industrial scale applications.The mode is selected and easily configured from the keyboard during initial setup. The unit will operate in the mode selected until the user reconfigures it.
mode 0: Push-button tare.Used for basic gross or net mode weighing.
mode 1 : Keyboard tare.Allows the user to keyboard enter a tare weight which can be used for net weight calculation.
mode 2 : Accumulate with Running Total.Accumulate gross or net weights and maintain running total for job, lot, etc. Calculates G,T,N, totals.
mode 3 : Print Weight With Subtotal and Total.You can print the lot or job or lot subtotal whenever needed. Totalized and clear at the end of the run.
mode 4 : Manual (Axle) Weigh.Push the PRINT button to sequentially number and print a series of weighments. Push the TOTAL button to print and clear the total and reset the sequence number.
mode 5 : Automatic (Axle) weigh.This mode operates similar to mode 4 except printing is automatic when motion settles. Traffic light control, trip level selection, and delay times for control functions are provided.
mode 6 : Automatic Axle weight On Long Scales.Weigh by axle on a truck scale. weight on the scale is automatically tared off after each weihgment.Operation, controls and selections are the same as mode 5.
mode 7 : Peak Hold mode.Display and print the peak weight detected by the indicator in the gross or net mode.
mode 8 : Over / Under Check weigh.Provides three TTL outputs and two set points. Outputs can be used with lights or alarms to indicate weight on the scale is over, under, or between set point weights.
mode 9 : bulk weigh.Features a set point with remote start / stop option and fill control relay signal. Scale empty weight and draft weights are configurable. Use for multiple drafts with total and subtotal printing.
