Eastwood, 14270ZP, High-Build Self-Etching Gray Primer for Automotive Car Paint
Features:
- Etches and primes bare metal in 1 step
- Fills-in imperfections, sands easily
- Strengthens adhesion, durability, and color hold-out
- Use with non-epoxy primers and topcoats
- Made in the USA
Get a newly-fabricated part or body panel ready for its finishing touches with Eastwood High-Build Self-Etching Primer in Gray. This sandable primer is the best high-build primer for a car, filling in imperfections as it prepares bare metal for a non-epoxy topcoat. The result is a smooth surface that improves the color hold-out of the paint or primer added on top.
Eastwood's high-build primer has a true acid-etching formula that sticks to virtually any metal that's clean, bare, and rust-free. This lacquer-based metal-etching primer improves the adhesion and durability of most non-epoxy topcoats while its high-build capabilities allow you to fill in low spots and level surfaces before topcoating. Visit the Eastwood Garage for five great ways to use epoxy primer as part of your painting project.
Eastwood's High-Build Self-Etching Primers have a true acid-etching formula that sticks to virtually any clean, bare, rust-free metal. These lacquer-based, metal-etching primers improve the adhesion and durability of most non-epoxy topcoats, and their high-build capabilities allow you to fill-in low spots and level-out surfaces prior to top-coating. When you use the quart or gallon can, you'll need a 1.8-2.0mm nozzle to spray these primers.
Eastwood's High-Build Self-Etching Primers improve the adhesion, durability, and color hold-out of topcoats. Not only do they etch and prime in one step, but their high-build formula also fills-in imperfections.If you're sanding primer or body filler you have to check out the Eastwood Elite Contour DSB Dustless Sanding Block System that gives you laser straight panels while keeping you and your shop clean because it eliminates 95% of the sanding dust.
Instructions
Ensure are to be applied is clean and free of waxes, grease and dirt. Use Eastwood's PRE Painting Prep to clean the surface. Apply directly to bare metal. Apply several light coats until desired thickness and coverage is achieved. wait 15 to 30 minutes between coats, full cure in 4 8 hours depending on conditions. For optimum results, apply at 70 dgerees F at 50% humidity or less.
Safety Information
Always wear eye, skin and respiratory protection. Always apply in a well-ventilated area away from open flame. Consult MSDS for specific hazards and warnings.
