BWI Eagle, 60-9100, Two-Timer Plus Suppression Complete System with Sensor Control
Features:
- User adjustable timers allow for custom tuning of changing dust conditions.
- Swivel spray nozzles direct water efficiently over the dust area.
- The Two-Timer Plus adds sensor control to detect when the belt is running.
The EAGLE® TWO-TIMER PLUS is an enhanced version of the original TwoTimer. A sensor input connector has been added to the left side of the control unit. A standard speed sensor (Model10-7003) should be attached to this input. This will allow the user to detect that the conveyor is running and eliminate the need to run a 120 VAC line back to the motor starter. The control unit can now be powered by any convenient 120 VAC source. Install the sensor on a conveyor roller or shaft (see sensor installation page). The operation of the TWO-TIMER PLUS is as follows: When the non-contacting sensor detects motion from the conveyor roller, a signal is sent to the control unit to start the "spray on" cycle. As long as the control unit is detecting ample pulses from the sensor (100 RPM or greater), the unit will continue to cycle the on and off times set by the user. If the conveyor roller slows down or stops, the TWO-TIMER PLUS will stop spraying and stay in the "spray off" cycle. When the conveyor re-starts and comes up to speed, the sensor will signal the control unit to turn on the sprays at the beginning of the "spray on" cycle. * A memory I.C. has been added to this model. If enabled (the default if OFF), the unit will "remember" the cycle and the time left in the cycle when the conveyor stopped. For example; the conveyor stops six minutes into a twelve-minute spray cycle. The spray automatically stops when the belt stops. When the belt restarts, spraying continues with the six minutes left in the cycle.
For more information, please see 
Data Sheet
