Features:
- Ethernet Control and monitoring of amplifier functions, with front panel COM activity, LED
- Serial data port for use with Ashly remote control devices
- Use Protea™ Software to remotely disable all front panel controls, including the on/off switch, for a tamper-proof installation
- Real-Time Clock with Event Scheduler
- Instant Standby Mode 30% reduction in power consumption with on/off and Preset Recall, both via contact closure, software control, or event scheduler
- Programmable power-on delay
- Aux preamp outputs, and fault condition logic outputs
- Rear panel DIP switches select low impedance, constant voltage, high pass filter, limiter, and input gain on each channel
- Ashly Energy Management System (EMS) for increased efficiency) automatic <1Wsleep-mode (defeatable)
- Extensive protection circuitry
- Continuously variable cooling fans
- Front panel power switch and level controls (can be disabled for security)
- Multiple internal power supplies provide increased channel separation and reliability
- Remote DC level control on each input channel (2 RU models only)
- Genuine Neutrik® connectors on 2 RU models for security, safety, and reliability
- Safety / Compliance: cTUVus, CE, FCC, RoHS
The unit shall be a 2-channel multi-mode amplifier capable of driving 2 Ohm loads at full power. The maximum rated output power shall be 800W per channel at Low Z, 70V, and 100V mode. There shall be an automatic but defeatable sleep mode consuming <1W, and an instant standby mode controlled by contact closure or software.
Each channel shall have remote DC level control. Input connectors shall be Neutrik® XLR/TRS combo jack and Euroblock, while output connectors shall be Neutrik® speakON. The unit shall have a front panel power switch and level controls that can be disabled. LEDs shall indicate Protect, Sleep, Disabled, Com, and Bridge mode status, as well as Temperature, Output Current, Output Signal, and Clipping/Mute status per channel.
The unit shall have Ethernet control with a real-time clock for event scheduling. The amplifier shall have temperature-dependent variable speed forced-air cooling.
For more information, please see 
Data Sheet
