Altronix, AL1024NKA8D, Dual Voltage Access Power Controller with Power Supply/Charger, BC400 Encloshure
AL1024NKA8D Includes Only:
- Enclosure, 15.5"H x 12"W x 4.5"D, Gray, 19 Gauge, Indoor
- Power Supply Charger, Single Fused Output, 24VDC at 10A, 115VAC, Board
- Dual Input Access Power Controller, 8 PTC Protected Outputs, Board
- Voltage Regulator. 24VDC input into 5VDC or 12VDC output
Features:
- Unit provides 12VDC or 5VDC up to 6A and/or 24VDC up to 10A (240W total power)
- Short circuit and overvoltage protection
- Supervision
- AC Fail;
- Battery Fail and Battery Presence
- Bi-colored LEDs provide visual verification of voltage on each output
- Stackable sub-assemblies save valuable space
- Built-in charger for sealed lead acid or gel type batteries
- Instantaneous transfer to stand-by batteries
- Eight (8) independently controlled outputs
- Eight (8) auxiliary power outputs (unswitched).
- Filtered and electronically regulated outputs
- Fire Alarm disconnect (latching or non-latching) is individually selectable for any or all of the eight (8) outputs
- Kit contents are UL Listed sub-assemblies
- CE European Conformity
Altronix AL1024NKA8D sub-assembly kit converts a 115VAC 60Hz input into eight (8) PTC protected outputs. Outputs are individually selectable, providing 12VDC or 5VDC up to 6A and/or 24VDC up to 10A (240W total power) for access control panels, door locks, and ancillary devices. Power outputs can be converted to dry form "C" contacts. Outputs are activated by an open collector sink, normally open (NO), normally closed (NC) dry trigger input, or wet output from an Access Control System, Card Reader, Keypad, Push Button, PIR, etc. AL1024NKA8D will route power to a variety of access control hardware devices including Mag Locks, Electric Strikes, Magnetic Door Holders, etc. Outputs will operate in both Fail-Safe and/or Fail-Secure modes. The FACP Interface enables Emergency Egress, Alarm Monitoring, or may be used to trigger other auxiliary devices. The fire alarm disconnect feature is individually selectable for any or all of the eight (8) outputs. The spade connectors allow you to daisy chain power to multiple ACMS8 modules. This feature allows you to distribute the power over more outputs for larger systems.
