Alderon, 2009598, Vizzynotifier VZW-031C WiFi, 1-Zone, Type 1 (Indoor), 120VAC, NO BUZZER, 15' Altra™ Narrow Angle Control Switch, Normally Open (High Level), 120/240VAC, 5A, RubberLox Pipe Clamp, Bagged
Features:
- (1) Power LED - A green LED illuminates (solid) on the front of the alarm panel to indicate the power is on.
- (2) Alarm LED - During an alarm condition, the red alarm LED will illuminate (solid/slow flash) on the front of the alarm panel. (3) WiFi LED - A blue LED illuminates (slow flash) when a WiFi connection is established and (solid) when connected to Vizzy.Site™.
- (4) Test Pushbutton - Press to test the alarm; all LEDs should illuminate (quick flash). Note: There is no alarm buzzer.
- (5) WiFi Connect Pushbutton - Press to select either WPS or HTTP mode and establish a WiFi connection to an IP address. (6) Sensor Inputs - Connect a field installed sensor to the terminals from the monitoring area.
- (7) Auxiliary Contacts - Interface with an external device including BAS systems and phone dialers. The normally open dry contacts can switch 30VDC, 700mA maximum (each).
- (8) Battery Backup - Install (3) AA batteries (not included) for battery backup during power outages. The green power LED will illuminate (slow flash) during battery backup mode to conserve battery power.
- (9) Panel Access - Pull the cover off to access the panel, includes an open wiring compartment to safely route wires while connecting sensors and auxiliary dry contacts.
The Vizzynotifier™ 1-Zone WiFi Alarm is an indoor rated alarm panel, powered by a standard 120VAC wall outlet. The green power LED will illuminate (solid) when powered. The Vizzynotifier™ is a multipurpose alarm panel that can be used for a variety of applications, including but not limited to: septic tanks, sumps, holding tanks, pump chambers, water tanks, flow, pressure, condensate, temperature, and any others where a "dry" contact can be connected to the alarm panel. Connect and register your wireless device to the Alderon™ cloud based Vizzy.site™ to begin monitoring and receiving text and email alerts for system conditions.
The alarm panel is equipped with visual alarm indication only (no alarm buzzer), activated by a normally open sensor wired to the terminals and/or the low battery alarm detection. A variety of sensors can be used such as a float switch, pressure switch, or any "dry" type sensor that "closes" during an alarm condition (normally open). Installing (3) AA batteries (not included) provides battery backup during power outages. Use the auxiliary contacts to connect to building automation systems (BAS) and phone dialers. Multiple sensors (signaling device) can be connected for expanded monitoring.
An alarm condition occurs when the sensor (signaling device) contact is activated, during which the red alarm LED will illuminate (solid) and the auxiliary contacts will activate. The alarm condition will stay on until the sensor is deactivated, during an alarm condition the alarm LED remains on (solid) with activated auxiliary contacts (alarm LED slow flash). The alarm condition will reset when the sensor deactivates and the alarm panel will auto reset for the next alarm cycle
For more information, please see 
Data Sheet and Quick Start Quide
