Advanced Systems & Designs, 600-22-QC2000-MTI, FlashCable Digimtatic Gage Interface for Metronics QC2000 Display
Features:
- Digimatic output FlashCable for Metronics QC2000 Quadra-Chek Inspection Display
- Sends data to GageMux or devices that recognize the Digimatic Signal
- Several options to trigger data
Send Data to GageMux Gage Interface Or Other Digimatic Input Devices.This FlashCable gage interface is engineered to change the output on the Metronics QC2000 ML-MT or Quadra-Chek 2000 Digital Readout Inspection Display to an output in a Digimatic format. The special 25-Pin male connector on the Advanced Systems & Designs FlashCable gage interface connects directly to the 25-Pin female connector on the Metronics QC2000 Quadra-Chek Inspection Display.
Designed to work with GageMux gage interface or other similar devices that recognize the Mitutoyo Digimatic signal. The FlashCable gage interface does not obtain any power from the gage. When connected to the GageMux, pin 9 of the 10-pin input port provides the power to the FlashCable gage interface. If using devices, other than the GageMux, make sure pin 9 of the 10-pin connector provides a 5VDC supply to the FlashCable. When the FlashCable is connected to the GageMux, the LED on the FlashCable turns GREEN. This indicates that the FlashCable is connected properly. The LED turns RED when the data is being sent or a data request is triggered.
The data transfer can be triggered using any of the following methods:
- Using the data send button on the gage, if it has one
- Sending a gage read command from the computer to the gage
A detailed operation manual is included with this FlashCable gage interface. The communication parameters can be changed and reconfigured per requirements for both theFlashCable and the device. Advanced Systems & Designs sets the FlashCable to the default settings on the Metronics QC2000 ML-MT Digital Readout Inspection Display. Refer to the operating manual on the Metronics QC2000 Quadra-chek display and make sure it is set to the same values as the FlashCable gage interface. Use the GageMux USB manual to see the reconfiguration instructions for the FlashCable gage interface. Six foot standard cable length.
